How to Fix Frigidaire Washer Error E1
Water is not entering the washer or the fill time is slow.
68 repair guides
Choose the appliance, then find the exact code. Every guide leads with what the code means, what to try first, and whether a part or replacement is worth considering.
Frigidaire
Water is not entering the washer or the fill time is slow.
Water is not entering the washer fast enough.
Water leak in the tub or air leak in the pressure sensor air hose.
Problem with the reed switch.
The washer is not draining.
The drain pump relay on the control board has failed.
Problem with the drain pump relay.
The lid is open or there is a door lock problem.
Water level pressure sensor isn't communicating with the electronic control board or there is a pressure sensor calibration problem.
Clogged air trap.
The washer is out of balance.
The door remains locked after the cycle is completed.
Control board problem or problem with the door lock circuit.
Control board problem.
Control board problem or problem with the door lock circuit.
Control board problem.
The control board thinks the door PTC circuit is open in spin.
The control board thinks the door PTC circuit is closed.
Control detects a problem with the door lock circuit.
Motor overheating or an issue with the water temperature sensor.
High motor current.
High current on inverter.
High current on motor phase.
No tacho signal for 3 seconds.
High temperature on the heat sink.
High temperature on the heat sink.
High temperature on the heat sink or a motor-related issue.
Communication problem/failure.
Communication problem.
Communication problem/failure.
Incorrect input voltage on the microprocessor.
Cold water is not entering or the control board is not seeing the correct water supply.
Wash NTC (heater) failure.
Water temperature sensor circuit failure.
NTC temperature for the cold water valve is over the limits.
Console control problem.
Console control problem.
User interface board or UI/main board communication failure.
Console or Main Board control problem/failure.
Washer electronic control board internal memory failure or problem with console management.
Communication error.
Washer electronic control board and user interface board mismatch or console management issue.
Incoming power frequency is out of limits.
Incoming line voltage is above 130 VAC.
Excessive foaming due to too much detergent.
Clogged drain pump.
Too much soap.
NTC temperature for the hot water valve is over the limits.
Frigidaire
Cooling Cassette filter needs replacement.
Refrigerator thermistor (temperature sensor) is open.
Refrigerator thermistor (temperature sensor) is shorted.
Freezer thermistor (temperature sensor) is open.
Freezer thermistor (temperature sensor) is shorted.
Ice maker thermistor (temperature sensor) is open.
Ice maker thermistor (temperature sensor) is shorted.
Communication Error
Communication Error between Control Boards
Defrost Heater Failure
Defrost Sensor Failure
Freezer Fan Motor Failure
Ice Maker Fan Motor Failure
Low Temperature Alarm
Open Sensor (e.g., Temperature Sensor)
Power Failure. Indicates the unit has lost and regained power.
Shorted Sensor (e.g., Temperature Sensor)
Condenser Fan Motor Failure
Condenser Fan Motor Failure (Alternate Code)
Evaporator Fan Motor Failure