Frigidaire Washer Error E67

How to Fix E67 Error (Step-by-Step) Unplug the washer from the electrical outlet to prevent any risk of electric shock. Turn off the main water supply valves leading to the washer. Access the main control board, which is typically located inside the top panel or behind the rear access panel. Carefully disconnect all the wire harnesses attached to the board, taking a photo beforehand can help with reassembly. Remove the screws or clips holding the old control board in place and gently lift it out. Install the new main control board, securing it with the screws or clips. Reconnect all the wire harnesses to the new board, referencing the photo you took earlier to ensure correct placement. Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Frigidaire Washer Focused repair path: washer fill, drain, spin, lock, sensor, and control checks. Do not treat this as a reset-only problem if the code keeps returning; use what the appliance does during the failed part of the cycle to choose the next check. Unplug the washer for one minute, then restart only to confirm whether the same code returns after a clean power cycle. Check load balance, detergent level, water supply valves, inlet screens, drain hose height, and the drain path before replacing electronic parts. Inspect the lid or door lock, strike, harness, and connector if the symptom involves start, lock, or spin behavior. Match the timing of the fault to the likely part path: inlet valve, pressure sensor, drain pump, motor, lock assembly, wiring, or control. Use the complete Frigidaire washer model number before ordering parts, because the same code can use different assemblies across platforms. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Frigidaire model number from the appliance tag before ordering. The same error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, or control boards depending on the exact model. Recommended Parts to Check No exact official OEM part number is listed here because the correct Frigidaire washer part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Whirlpool washer drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Frigidaire washer model number. Confirm compatibility before buying. Why this category can matter: drain, no-spin, or water-removal symptoms after hose and filter checks. Search Amazon for Whirlpool washer drain pump Whirlpool washer water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Frigidaire washer model number. Confirm compatibility before buying. Why this category can matter: fill, slow-fill, and valve-related symptoms after supply checks. Search Amazon for Whirlpool washer water inlet valve Whirlpool washer control board Common replacement category: Main control board Fit note: Exact OEM part number varies by complete Frigidaire washer model number. Confirm compatibility before buying. Why this category can matter: repeating control or communication faults after connector checks. Search Amazon for Whirlpool washer control board Before ordering: match the part to the complete Frigidaire washer model number on the appliance tag. Still Not Working? If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure. Ask a Technician Online – Get Answer in Minutes Find a Local Repair Pro Near You Browse all Frigidaire error codes: Frigidaire Error Codes