How to Fix Frigidaire Washer Error E43

What to Check Next on This Frigidaire Washer

Focused repair path: washer fill, drain, spin, lock, sensor, and control checks. Do not treat this as a reset-only problem if the code keeps returning; use what the appliance does during the failed part of the cycle to choose the next check.

1. Unplug the washer for one minute, then restart only to confirm whether the same code returns after a clean power cycle.
2. Check load balance, detergent level, water supply valves, inlet screens, drain hose height, and the drain path before replacing electronic parts.
3. Inspect the lid or door lock, strike, harness, and connector if the symptom involves start, lock, or spin behavior.
4. Match the timing of the fault to the likely part path: inlet valve, pressure sensor, drain pump, motor, lock assembly, wiring, or control.
5. Use the complete Frigidaire washer model number before ordering parts, because the same code can use different assemblies across platforms.

Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Frigidaire model number from the appliance tag before ordering. The same error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, or control boards depending on the exact model.