Frigidaire Washer Error E56-2

How to Fix E56 Error (Step-by-Step) Disconnect the washer from its power source by unplugging the cord from the wall.Access the bottom of the washer, which may require carefully tilting the machine back and propping it up securely.Locate the drive motor and the motor control board. Visually inspect both for burn marks, melted connectors, or damaged wires.Ensure the wire harness connecting the motor to the control board is securely plugged in at both ends.A professional would use a multimeter to test the motor windings for continuity. If the motor fails the test, it requires replacement.If the motor tests good, the failure is likely in the motor control board, which will need to be replaced.After replacing the faulty component (either the motor or the control board), reassemble the washer and test its operation.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Frigidaire Washer Focused repair path: washer fill, drain, spin, lock, sensor, and control checks. Do not treat this as a reset-only problem if the code keeps returning; use what the appliance does during the failed part of the cycle to choose the next check. Unplug the washer for one minute, then restart only to confirm whether the same code returns after a clean power cycle. Check load balance, detergent level, water supply valves, inlet screens, drain hose height, and the drain path before replacing electronic parts. Inspect the lid or door lock, strike, harness, and connector if the symptom involves start, lock, or spin behavior. Match the timing of the fault to the likely part path: inlet valve, pressure sensor, drain pump, motor, lock assembly, wiring, or control. Use the complete Frigidaire washer model number before ordering parts, because the same code can use different assemblies across platforms. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Frigidaire model number from the appliance tag before ordering. The same error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, or control boards depending on the exact model. Verified Compatible Alternatives:134743500 (Motor Control Board) Still Not Working? If the replacement part didn't fix the issue, you may have a wiring problem or main board failure. Ask a Technician Online - Get Answer in Minutes Find a Local Repair Pro Near You