⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: DN Difficulty: Easy
Problem: Demo mode is active.
How to Fix DN Error (Step-by-Step)
- Make sure the dryer is plugged in and the power is on.
- Press and hold the ‘Dryness’ and ‘Options’ buttons at the same time.
- Continue holding both buttons for about 5-10 seconds and confirm the error stays cleared during a full test cycle.
- You should hear a beep or see the ‘DN’ code disappear from the display.
- The dryer is now out of demo mode and ready for normal operation.
- If this combination does not work, try pressing and holding the ‘Temperature’ and ‘Dryness’ buttons together for 5 seconds.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply