⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: I60, E60 Difficulty: Hard
Problem: Water heating problem. The dishwasher is not heating the water correctly.
How to Fix I60, E60 Error (Step-by-Step)
- Disconnect the dishwasher from power and confirm the error stays cleared during a full test cycle.
- To access the heating element and thermostat, you will need to pull the dishwasher out from its installation.
- The heating element is located at the bottom of the tub. Inspect it for any visible signs of damage or burnout.
- Use a multimeter to test the continuity of the heating element. A lack of continuity indicates a faulty element.
- Disconnect the wires from the old heating element and remove it. Install the new element and reconnect the wires.
- Locate the high-limit thermostat, usually near the heating element, and test it for continuity as well. Replace if faulty.
- Reinstall the dishwasher and run a cycle that requires heating to verify the repair.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 154825001
- 50277796004
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply