Error Code: F8 E1 Difficulty: Moderate
Problem: Low Flow of Water
How to Fix F8 E1 Error (Step-by-Step)
- Unplug the washer and turn off the hot and cold water supply lines.
- Place a towel behind the washer to catch any residual water and disconnect the water inlet hoses from the back of the machine.
- Remove the screws from the back panel to access the water inlet valve at the top.
- Disconnect the wire harnesses attached to the valve solenoids and confirm the error stays cleared during a full test cycle.
- Remove the screws holding the water inlet valve assembly in place and remove the old valve.
- Install the new water inlet valve (Part: W11220230, 205613, or W11210459) and secure it with its mounting screws.
- Reconnect the wire harnesses and water hoses, then turn the water on and check for leaks before plugging the washer back in.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- W11210459 (Water Inlet Valve)
- W11220230 (Water Inlet Valve)
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply