Error Code: F3 E1 Difficulty: Hard
Problem: Pressure System Fault
How to Fix F3 E1 Error (Step-by-Step)
- Disconnect the washer from power and turn off the hot and cold water supply valves.
- Pull the washer away from the wall and remove the rear access panel.
- Locate the pressure sensor, which is typically a small, round component with a thin rubber tube and a wire connector attached, usually near the top of the tub.
- Carefully detach the rubber tube from the sensor and unplug the electrical connector.
- Remove any screws or clips holding the old sensor in place and install the new one.
- Reconnect the rubber tube and the wire harness to the new pressure sensor.
- Reinstall the back panel, reconnect the water hoses, and plug the washer in to test.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply