Amana Washer Error F22-2

How to Fix F22 Error (Step-by-Step) Unplug the washing machine from its power source and confirm the error stays cleared during a full test cycle. Open the washer door. The door lock assembly is located on the front frame of the washer, where the door latch engages. To access it, you must peel back the large rubber door seal (bellow). Find the outer wire spring clamp holding the bellow in place and carefully pry it off with a flathead screwdriver. With the clamp removed, peel the bellow away from the frame in the area of the door lock. You will now see the screws that secure the door lock assembly. Remove these screws. Reach in and pull the lock assembly out. Take a photo of the wire connector, then disconnect it. Connect the new door lock, mount it in place with the screws, and carefully re-secure the rubber bellow with its spring clamp. Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Washer Focused repair path: washer fill, drain, spin, lock, pressure, motor, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Unplug the washer for one minute, then restart only to confirm whether the same code returns after a clean power cycle. Check load balance, detergent level, supply valves, inlet screens, drain hose height, and the drain path before replacing electronic parts. Inspect the lid or door lock, strike, harness, and connector if the symptom involves start, lock, or spin behavior. Match the timing of the fault to the likely part path: inlet valve, pressure sensor, drain pump, motor, lock assembly, wiring, or control. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. Recommended Parts to Check No exact official OEM part number is listed here because the correct Amana washer part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Whirlpool washer drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Amana washer model number. Confirm compatibility before buying. Why this category can matter: drain, no-spin, or water-removal symptoms after hose and filter checks. Search Amazon for Whirlpool washer drain pump Whirlpool washer water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Amana washer model number. Confirm compatibility before buying. Why this category can matter: fill, slow-fill, and valve-related symptoms after supply checks. Search Amazon for Whirlpool washer water inlet valve Whirlpool washer control board Common replacement category: Main control board Fit note: Exact OEM part number varies by complete Amana washer model number. Confirm compatibility before buying. Why this category can matter: repeating control or communication faults after connector checks. Search Amazon for Whirlpool washer control board Before ordering: match the part to the complete Amana washer model number on the appliance tag. Still Not Working? If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure. Browse all Amana error codes: Amana Error Codes