How to Fix Amana Dryer Error E2

Error Code: E2 Difficulty: Moderate

Problem: Indicates a shorted thermistor, causing the dryer to misread the temperature.

How to Fix E2 Error (Step-by-Step)

1. Unplug the dryer from the power source to prevent electrical shock.
2. Remove the lower front panel to gain access to the internal components. This panel is often held by two screws at the bottom or clips at the top.
3. Find the thermistor mounted on the exhaust blower housing. It’s a small plastic sensor with two wires leading to it.
4. Carefully unplug the wire connector from the old thermistor and confirm the error stays cleared during a full test cycle.
5. Use a nut driver or screwdriver to remove the single screw securing the thermistor to the housing.
6. Place the new thermistor (Part: WP8577274) into the housing, fasten it with the screw, and plug the wire connector back in until it clicks.
7. Reattach the lower panel, restore power to the dryer, and verify the fix by starting a new cycle.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes