⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Washer Difficulty: Moderate
Problem: Water Temperature Sensor (NTC) Error
How to Fix Washer Error
- Unplug the washer from power source.
- Remove the lower front access panel to access the heating element area.
- Locate the temperature sensor (thermistor) mounted on the heating element or tub.
- Disconnect the electrical connector from the temperature sensor.
- Remove the mounting screw or clip securing the sensor in place.
- Gently pull the sensor out of its mounting hole.
- Inspect the sensor tip for any corrosion or damage.
- Apply a small amount of thermal grease to the tip of the new sensor.
- Insert the new sensor into the mounting hole until fully seated.
- Secure with the mounting screw and reconnect the electrical connector.
- Reassemble the access panel and test the heating function with a warm water cycle.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Maytag model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →
Leave a Reply