⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Washer Difficulty: Moderate
Problem: Water Temperature Sensor / Heating System
How to Fix Washer Error
- Unplug the washer completely from power.
- Remove the front lower access panel to access the door lock assembly.
- Locate the door latch mechanism behind the door strike plate.
- Disconnect the electrical connector from the door lock assembly.
- Remove the mounting screws securing the door lock to the front panel.
- Carefully pull out the door lock assembly, noting the position of any actuator rods.
- Inspect the old lock for broken parts or worn contacts.
- Install the new door lock assembly, ensuring the actuator rods align properly with the door mechanism.
- Reconnect the electrical connector and secure mounting screws.
- Test the door lock by closing the door and starting a cycle to verify it locks and unlocks properly.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Maytag model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →
Leave a Reply