⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Washer Difficulty: Moderate
Problem: Pressure Sensor / Water Level Detect Error
How to Fix Washer Error
- Unplug the washer from power.
- Remove the top panel by unscrewing the rear mounting screws.
- Locate the pressure switch (water level sensor) usually mounted on the right side wall.
- Disconnect the thin air pressure hose from the switch and blow through it to check for blockages.
- Remove the electrical connectors from the pressure switch terminals.
- Unscrew the mounting screws holding the pressure switch in place.
- Install the new pressure switch and reconnect the air hose securely.
- Reconnect the electrical connectors ensuring they click into place.
- Reassemble the top panel and test the washer by running a short cycle to verify proper water level detection.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Maytag model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Maytag error codes: Maytag Error Codes
Leave a Reply