⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Dryer Difficulty: Easy
Problem: Door switch circuit failure—switch not detecting closed door position
How to Fix Dryer Error
- Unplug dryer and open door.
- Locate door switch WPW10441007 mounted on front panel frame where door latch strikes.
- Manually press switch plunger—should click audibly and feel positive engagement.
- Disconnect wiring harness from switch terminals.
- Set multimeter to continuity mode and test switch: plunger pressed = continuity, plunger released = open circuit.
- If switch fails continuity test, replace WPW
- Remove mounting screws (typically 2 screws) and extract old switch.
- Install new switch ensuring proper alignment with door strike—door must fully depress plunger when closed.
- Reconnect wiring harness securely.
- Close door firmly and start test cycle—dryer should operate normally. If error returns, check door alignment and strike plate position—bent door frame can prevent full switch engagement.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Maytag model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →
Leave a Reply