⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Refrigerator Difficulty: Moderate
Problem: Compressor winding temperature sensor fault
How to Fix Refrigerator Error
- UNPLUG unit.
- Remove rear lower access panel to access compressor.
- Locate temperature sensor clipped to compressor shell (small probe with 2 wires, often under tape).
- Carefully peel back tape/clamp to access sensor connector.
- Disconnect and test resistance (should read 5k-15k ohms at room temp).
- Replace sensor if open/shorted.
- Reattach new sensor to compressor shell in same location using high-temp adhesive or metal strap – MUST maintain good thermal contact.
- If sensor good but error persists, suspect failing compressor windings causing actual overtemperature condition – requires professional diagnosis.
As an Amazon Associate, we earn from qualifying purchases through links on this page.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Kenmore model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Kenmore error codes: Kenmore Error Codes
Leave a Reply