Kenmore Dryer Error HC

How to Fix Dryer Error Turn off power supply immediately.Allow dryer to cool completely.Remove rear access panel.Locate high limit thermostat on heater housing or blower housing.Disconnect electrical connector from thermostat.Test thermostat continuity with multimeter (should read closed when cool).If thermostat is open, remove mounting screws and replace thermostat.Inspect heater element for short circuits or grounding issues.Check wiring harness for damage or corrosion.Restore power and test heating cycle with temperature monitoring.

What to Check Next on This Kenmore Dryer Kenmore Dryer Error HC: Use the code or symptom as the starting clue, then confirm what the dryer actually does before ordering parts. Unplug the dryer before checking the heater, thermal fuse, thermostat, motor, belt, door switch, sensors, or control wiring. Clean the lint screen and confirm strong airflow through the full vent path before replacing heat or control parts. Check the door switch, drum movement, belt, rollers, moisture sensor bars, loose connectors, and signs of overheating. Run a timed-dry test after airflow corrections and note whether the failure is no start, no heat, weak airflow, long dry time, or control behavior. Replace a part only after the same symptom repeats and the complete Kenmore dryer model number confirms compatibility. If the issue returns after these checks, match replacement parts to the complete Kenmore dryer model number from the appliance tag. Kenmore models can be built by different manufacturers, so fit depends on the full model number. As an Amazon Associate, we earn from qualifying purchases through links on this page.