How to Fix Frigidaire Washer Error EF1

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: EF1 Difficulty: Easy

Problem: Clogged drain pump.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix EF1 Error (Step-by-Step)

Unplug the washer from the electrical outlet and confirm the error stays cleared during a full test cycle.
Prepare some towels and a shallow pan to catch residual water.
Locate the small access door for the pump filter, usually on the bottom front corner of the washer.
Open the door and slowly unscrew the filter cap, allowing the water to drain into the pan.
Once drained, completely remove the filter and clean it thoroughly of any lint, hair, coins, or other debris.
Check inside the filter housing for any obstructions as well.
Screw the filter back in securely, close the access door, and plug the washer back in.
Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.