Skip to main content
Appliance Fix Guide

Electrolux Dishwasher error code

Electrolux Dishwasher Error I5B

Wash pump motor issue.

Wash pump motor issue.

ModerateStart with 5-15 minutes of safe checks
⚠️ CHECK WARRANTY / AGE$100 - $250 Range
Electrolux dishwasher repair guide for error I5B
Error codeI5BDishwasher

Start here before buying a part or taking the appliance apart.

  1. 1
    Disconnect the dishwasher from its electrical power source

    Disconnect the dishwasher from its electrical power source at the circuit breaker.

  2. 2
    Shut off the hot water supply line, typically

    Shut off the hot water supply line, typically located under the sink.

  3. 3
    Carefully slide the dishwasher out from its cabinet

    Carefully slide the dishwasher out from its cabinet and lay it on its back on a protective surface.

A quick explanation

What does I5B mean?

Wash pump motor issue.

The answer you came for

How to fix Electrolux dishwasher error I5B

Start with the safest checks and work from simple to technical.

  1. 1

    Disconnect the dishwasher from its electrical power source

    Disconnect the dishwasher from its electrical power source at the circuit breaker.

  2. 2

    Shut off the hot water supply line, typically

    Shut off the hot water supply line, typically located under the sink.

  3. 3

    Carefully slide the dishwasher out from its cabinet

    Carefully slide the dishwasher out from its cabinet and lay it on its back on a protective surface.

  4. 4

    Locate the wash pump and motor assembly on

    Locate the wash pump and motor assembly on the bottom of the dishwasher tub.

  5. 5

    Before replacing, check that the wiring to the

    Before replacing, check that the wiring to the motor is secure and undamaged and that the connected hoses are not kinked.

  6. 6

    If connections are good, the motor has likely

    If connections are good, the motor has likely failed and the entire pump assembly (Part #154844301, #807473201, or #154853801) needs to be replaced.

  7. 7

    Install the new pump, reattach hoses and wires,

    Install the new pump, reattach hoses and wires, set the dishwasher upright, and reconnect all utilities to test.

  8. 8

    Turn the appliance off, wait about 2 minutes,

    Turn the appliance off, wait about 2 minutes, then turn it back on.

Read the additional checks from the current guide

How to Fix I5B Error (Step-by-Step) Disconnect the dishwasher from its electrical power source at the circuit breaker.Shut off the hot water supply line, typically located under the sink.Carefully slide the dishwasher out from its cabinet and lay it on its back on a protective surface.Locate the wash pump and motor assembly on the bottom of the dishwasher tub.Before replacing, check that the wiring to the motor is secure and undamaged and that the connected hoses are not kinked.If connections are good, the motor has likely failed and the entire pump assembly (Part #154844301, #807473201, or #154853801) needs to be replaced.Install the new pump, reattach hoses and wires, set the dishwasher upright, and reconnect all utilities to test.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:154844301154853801807473201

If the code comes back

Do not keep replacing parts based only on the code. Repeat the safe checks above. If the fault remains, stop and arrange qualified service rather than ordering from the code alone.

Recommended part

Recommended part for this error code

Part listed in the current guide

OEM candidate: 154618701

Price noted in the current guide: $20-$260

Why this part is shown: It is associated with Electrolux Dishwasher error I5B in the current guide. The error code alone does not prove this part has failed.

Compatibility varies by model. Confirm that the Amazon listing includes your complete dishwasher model number before ordering.

Amazon part link View recommended part on Amazon

You can open the recommendation now. Check model compatibility on the Amazon page before purchasing.

Affiliate disclosure: qualifying purchases may earn this site a commission at no additional cost to you.

Replacement options

Ready to replace your dishwasher?

If repairing this dishwasher no longer feels worthwhile, compare three replacement paths below.

Why shop your replacement on Amazon?

  • Fast, free delivery

    Prime members can get fast, free delivery on eligible items.

  • Convenient delivery options

    Select large appliances may offer scheduled or Room of Choice delivery.

  • Haul-away options

    Haul-away may be available for select appliances and delivery areas.

  • Installation help

    Installation or assembly may be available on select items.

Delivery and service options, fees, and availability vary by item, seller, and delivery ZIP code. Confirm available services at Amazon checkout.

Affiliate disclosure: qualifying purchases may earn this site a commission at no additional cost to you.

Make the money decision

Repair or replace calculator

Use the age and total repair estimate to get a simple comparison. This is guidance, not a guarantee.

Safety first

Disconnect power before opening panels or touching internal parts.

When to stop
  • Stop if you see burned wiring, melted connectors, water near electrical parts, or a gas smell.
  • Do not perform live-voltage testing unless you are trained and equipped for it.
  • Use the exact model manual or service information before replacing electronic controls.

Free quick sheet

Get the Electrolux Dishwasher Error Code Quick Sheet

A concise reference with code meanings, severity, first checks, and when it is time to stop and call for service.

The form will be enabled after the existing subscriber database and PDF delivery are connected securely.

No spam. Unsubscribe anytime.