⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F# E# Difficulty: Easy
Problem: System Code Error
How to Fix F# E# Error (Step-by-Step)
- Unplug the washer from the wall outlet to completely remove power.
- Wait for 5 full minutes. This allows the internal computer (the main control board) to discharge and reset itself.
- Plug the washer’s power cord back into the outlet and confirm the error stays cleared during a full test cycle.
- Within 30 seconds of plugging it back in, open and close the washer lid 6 times. You must open it more than 2 inches each time, and the lid must fully close each time. This sequence signals the control board to clear stored error codes.
- Select a simple ‘Rinse & Spin’ cycle and press the Start button to see if the reset was successful.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
- Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.
Parts Availability Note: For this Electrolux/Frigidaire error code, exact OEM part numbers can vary by model revision and serial range. We’ve listed the most likely component(s), but confirm compatibility using your full model number before ordering. If no exact SKU is shown, use this guide for diagnosis first, then verify the matching OEM part on RepairClinic or PartSelect.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply