Amana Dishwasher Error ALL-CYCLE-AND-OPTION-LIGHTS-FLASHING

How to Fix ALL CYCLE AND OPTION LIGHTS FLASHING Error (Step-by-Step) Begin by closing the dishwasher door firmly and pressing the ‘Start/Resume’ button to see if the cycle continues. This is the most common reason for this alert. If the lights continue flashing, perform a power reset. Turn off the circuit breaker that supplies power to the dishwasher for 5-10 minutes. Restore power and try to start a new cycle. If the error persists, it may indicate a faulty door latch or control board. Turn the power off at the circuit breaker again for safety. Open the dishwasher door and locate the main electronic control board, usually found behind the lower kickplate or within the door panel itself. Carefully disconnect the wire harnesses from the old board, taking a picture first to remember their placement. Remove the old board. Install the model-matched control board only after confirming compatibility with the complete dishwasher model number, then reconnect the wires and reassemble the dishwasher. Turn the power back on and test the dishwasher and confirm the error stays cleared during a full test cycle. Amana Dishwasher Checks Before Replacing Parts Cut power at the breaker for at least one minute, then restore power and run a short cycle to see whether the same code or light pattern returns. Open the door and inspect the latch, strike, racks, spray arms, float, filter, and lower sump for anything that can interrupt the cycle or block water movement. Check the drain hose loop, sink knockout, disposer connection, and air gap if the symptom involves standing water, repeated draining, or a cycle that will not complete. Use the complete model number from the door or tub tag before ordering any pump, valve, latch, heater, sensor, or control-board category part. If the fault returns immediately after these checks, document the exact lights, beeps, and cycle stage; repeated electronic faults usually need meter testing before parts are replaced. Recommended Parts to Check Use these as symptom-based starting points, then confirm the exact fit with the full Amana dishwasher model number from the door or tub tag before ordering. Start here Amana dishwasher drain pump Most likely when: water stays in the tub, draining sounds weak, or the cycle stops before completing. Check first: filter, drain hose, disposer knockout, air gap, and the drain path. Find compatible Amana dishwasher drain pumps Also check Amana dishwasher water inlet valve Most likely when: the tub does not fill, fills slowly, or stops early after the supply checks out. Check first: shutoff valve, float, inlet screen, water pressure, and harness connection. Find compatible Amana dishwasher inlet valves If controls act up Amana dishwasher control board Most likely when: lights stay stuck, buttons do not respond normally, or the fault returns after wiring and reset checks. Check first: breaker reset, door switch signal, keypad response, visible board damage, and loose connectors. Find compatible Amana dishwasher control boards If the door interrupts cycles Amana dishwasher door latch or switch Most likely when: the cycle starts and stops, lights blink after closing, or symptoms change when the door is moved. Check first: latch strike alignment, door seal pressure, connector fit, and switch continuity. Find compatible Amana dishwasher door latch switches