How to Fix Amana Dishwasher Error ALL CYCLE AND OPTION LIGHTS FLASHING

Error Code: ALL CYCLE AND OPTION LIGHTS FLASHING Difficulty: Hard

Problem: The cycle is suspended because the door was opened.

How to Fix ALL CYCLE AND OPTION LIGHTS FLASHING Error (Step-by-Step)

1. Begin by closing the dishwasher door firmly and pressing the ‘Start/Resume’ button to see if the cycle continues. This is the most common reason for this alert.
2. If the lights continue flashing, perform a power reset. Turn off the circuit breaker that supplies power to the dishwasher for 5-10 minutes.
3. Restore power and try to start a new cycle. If the error persists, it may indicate a faulty door latch or control board.
4. Turn the power off at the circuit breaker again for safety.
5. Open the dishwasher door and locate the main electronic control board, usually found behind the lower kickplate or within the door panel itself.
6. Carefully disconnect the wire harnesses from the old board, taking a picture first to remember their placement. Remove the old board.
7. Install the new control board (W11613566 or W10814355), reconnect the wires, and reassemble the dishwasher.
8. Turn the power back on and test the dishwasher and confirm the error stays cleared during a full test cycle.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes