⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Washer Difficulty: Moderate
Problem: Leak detection – float switch activated indicating water in base pan
How to Fix Washer Error
- Unplug washer immediately and turn off water supply valves.
- Tilt washer backward 45 degrees to access base pan (place wood blocks under front feet).
- Remove 3 screws securing base pan and lower carefully – expect standing water.
- Dry base pan completely with towels and shop vacuum.
- Locate source of leak: inspect inlet valve connections, drain pump seals, tub gasket, and hoses.
- Run washer briefly with water supply on to observe leak source (use flashlight).
- Common culprits: cracked drain pump housing, loose hose clamp, or torn tub seal.
- Replace leaking component (pump W11399437, hose WPW10351854, or tub seal W
- .
- Verify float switch resets after pan is dry (should show open circuit when dry).
- Reinstall base pan and test washer through complete cycle monitoring for leaks.
As an Amazon Associate, we earn from qualifying purchases through links on this page.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Whirlpool model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Whirlpool error codes: Whirlpool Error Codes
Leave a Reply