How to Fix Whirlpool Washer Error F7E8

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: Washer Difficulty: Hard

Problem: Motor drive overcurrent fault – excessive amperage draw detected

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix Washer Error

Unplug washer immediately to prevent motor/control damage.
Remove rear panel to access drive motor and transmission.
Manually rotate tub assembly – check for binding indicating bearing failure or foreign object obstruction.
Inspect drive belt for glazing, cracks, or improper tension (replace if worn).
Disconnect motor wiring harness and measure winding resistance (should be 4-6 ohms balanced between terminals).
Check for short to ground by measuring resistance between each terminal and motor frame (should be infinite).
Inspect motor control unit (MCU) for burnt components near power output stage.
If mechanical system checks good but error persists, replace MCU W
After replacement, run diagnostic cycle monitoring motor current draw (should not exceed 6 amps during normal operation).
If F7E8 returns immediately, suspect seized tub bearing requiring transmission replacement.

OEM Part #: W10312695

Estimated Market Price: $185

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your Whirlpool model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Whirlpool error codes: Whirlpool Error Codes