How to Fix Whirlpool Washer Error F22

Error Code: Washer Difficulty: Hard

Problem: Door/lid lock failure – lock mechanism not engaging or sensing circuit fault

How to Fix Washer Error

1. Unplug washer and attempt manual door/lid release per model-specific procedure (usually pull tab near lock).
2. Remove top panel (top-load) or lower kick panel (front-load) to access lock assembly.
3. Inspect lock mechanism for physical obstructions preventing engagement.
4. Disconnect lock wiring harness and measure resistance: primary coil should read 300-600 ohms, secondary 1000-1500 ohms.
5. Check lock strike plate alignment – should engage smoothly without binding.
6. Verify 120V AC reaches lock during operation (test at connector with door closed).
7. Inspect wiring harness between lock and control board for damage near hinge areas.
8. If lock tests electrically good but won’t engage, replace door lock assembly WPW
9. If lock receives no power or error persists after replacement, replace main control board W
10. After repair, verify lock engages within 3 seconds of cycle start and releases within 2 minutes after cycle completion.