How to Fix GE Dryer Error 003

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: 003 Difficulty: Moderate

Problem: Inlet thermistor issue – variant code for inlet temperature sensor

⚖️ Repair Decision

✅ WORTH FIXING

Parts under $100

How to Fix 003 Error

UNPLUG THE DRYER from the wall outlet to ensure safety.
The inlet thermistor is usually located on the blower housing or the heater assembly. You will need to remove the dryer’s front or rear panel to access it.
Disconnect the wire harness from the thermistor. Use a multimeter set to Ohms (Ω) to test the resistance across the two terminals.
At room temperature (~77°F/25°C), it should read approximately 10,000 ohms (10kΩ). If the reading is infinite (open circuit) or near zero (shorted), the thermistor has failed.
Remove the screw holding the old thermistor, install the new one, and reconnect the wire harness. Reassemble the dryer panel.

OEM Part #: WE04X25996 (Thermistor)

Estimated Market Price: $15-$35

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your GE model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Ge error codes: Ge Error Codes