How to Fix Samsung Washer Error 8E

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: 8E Difficulty: Hard

Problem: Overcurrent error – excessive amperage draw detected by inverter protection circuit

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix 8E Error

Unplug washer and inspect main power cord for damage or fraying near strain relief.
Check household circuit breaker for partial trip condition (reset fully OFF then ON).
Test noise filter DC96-00488A resistance between L-N (should read 1-2MΩ) and L-G/N-G (should read OL).
Measure inrush current during startup with clamp meter (should not exceed 15A for first 2 seconds).
If current normal but error persists immediately on power-up: replace main PCB DC92-01543A.
If current excessive: inspect all loads (heater, pump, motor) for shorts to ground using megohmmeter (>1MΩ required).
Verify proper grounding continuity from chassis ground lug to outlet ground terminal (<1Ω).

OEM Part #: DC92-01543A

Estimated Market Price: $210

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your Samsung model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Samsung error codes: Samsung Error Codes