⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: TE Difficulty: Moderate
Problem: The temperature sensor (thermistor) is broken or disconnected. The machine has stopped heating because it cannot read the water temperature. Replace the sensor if the wiring looks good.
How to Fix TE Error
- UNPLUG the washer from electrical power.
- Remove the lower front access panel to access the tub assembly.
- Locate the thermistor mounted on the front of the outer tub. Disconnect its wiring harness.
- Measure resistance across thermistor terminals using a multimeter set to resistance mode. At room temperature (70°F/21°C), reading should be approximately 10kΩ (±10%).
- If resistance reads infinite (open) or near zero (shorted), replace the thermistor.
- Remove the mounting screw securing the sensor. Extract old thermistor and install new OEM part DC34-00040A, ensuring metal surface makes full contact with tub wall.
- Reconnect wiring harness. Inspect entire harness path for damage near tub movement points; repair if necessary.
- Reassemble access panel. Run hot water cycle to verify temperature readings stabilize correctly.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Samsung model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →
Leave a Reply