⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: 3 Difficulty: Moderate
Problem: The water level is too high. This implies the water valve is leaking into the tub or the air hose connected to the pressure sensor is blocked.
How to Fix 3 Error
- UNPLUG washer from electrical power.
- Ensure lid closes fully with firm click. Check for obstructions preventing lid closure.
- Remove top panel or console assembly to access lid switch near hinge area.
- Test lid switch continuity with multimeter: switch must CLOSE when lid is pressed down (simulating closed position).
- If switch fails continuity test: disconnect wiring harness, remove mounting screws, extract old switch assembly.
- Install new lid switch using OEM part DC64-00120A. Ensure actuator arm aligns with lid strike plate.
- Adjust switch position if needed so lid fully depresses actuator when closed.
- Reassemble console. Test by opening/closing lid while observing control panel response—cycle should pause when open, resume when closed.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Samsung model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →
Leave a Reply