Blog
-
How to Fix Samsung Washer Error 9
Problem: The washer detects irregular voltage from the power outlet. This can be a home electrical issue, but often it is a failure of the main…
-
How to Fix Samsung Washer Error UbC
Problem: Rare code: Unbalanced during spin with suspension fault detected How to Fix UbC Error UNPLUG. Remove top/front panels. Inspect all 4 suspension rods: check for…
-
How to Fix Samsung Washer Error OE1
Problem: Water overflow detected during the fill cycle. The cold water inlet valve may be mechanically stuck open, forcing water into the machine continuously. How to…
-
How to Fix Samsung Washer Error OE2
Problem: Water overflow detected during the wash cycle. The hot water valve may be stuck, or the machine is siphoning water back in through the drain…
-
How to Fix Samsung Washer Error SC
Problem: Rare code: Steam generator error (steam-capable models) How to Fix SC Error UNPLUG. Access steam generator (front lower compartment). Descale unit with vinegar solution per…
-
How to Fix Samsung Washer Error HC1
Problem: The wash heater is overheating. The temperature sensor detected heat above safe limits. This is either a bad sensor or a stuck heater relay. How…
-
How to Fix Samsung Washer Error HC2
Problem: The dryer heater (on combo units) is overheating. This is usually caused by a blocked air duct or a bad fan preventing proper airflow over…
-
How to Fix Samsung Washer Error nd
Problem: No drain – water not evacuating within 15 minutes How to Fix nd Error Unplug washer and turn off water supply valves. Remove lower front…
-
How to Fix Samsung Washer Error 4E1
Problem: Water temperature sensor fault during fill cycle How to Fix 4E1 Error Verify cold water hose connected to cold inlet valve (common installation error). Disconnect…
-
How to Fix Samsung Washer Error 4E2
Problem: Incoming water temperature exceeds 50°C (122°F) for delicate cycles How to Fix 4E2 Error Confirm cold water supply hose connected to cold faucet (not hot…