Blog
-

How to Fix Kenmore Dishwasher Error F11
Problem: Water level sensor/pressure switch failure How to Fix Dishwasher Error Inspect pressure switch hose for kinks, leaks, or blockages. Check pressure switch connections for corrosion.…
-

How to Fix Whirlpool Washer Error F3E2
Problem: Temperature sensor fault – out of range reading from thermistor How to Fix Washer Error Unplug washer and remove lower front panel. Locate temperature sensor…
-

How to Fix Whirlpool Washer Error F4E1
Problem: Heater element failure – open circuit or short detected How to Fix Washer Error Unplug washer and turn off water supply. Remove lower front panel…
-

How to Fix Kenmore Dryer Error F26
Problem: Temperature sensor failure during timed dry cycle How to Fix Dryer Error Disconnect power at circuit breaker. Remove rear access panel. Locate thermistor sensor on…
-

How to Fix Whirlpool Washer Error F6E4
Problem: Leak detection – water detected in base pan activating float switch How to Fix Washer Error UNPLUG WASHER IMMEDIATELY and turn off water supply valves.…
-

How to Fix Kenmore Dishwasher Error F12
Problem: Communication error between control boards How to Fix Dishwasher Error Disconnect power for 10 minutes to reset all boards. Check all inter-board communication harnesses for…
-

How to Fix Whirlpool Washer Error F81
Problem: Lid lock failure – lid not locking properly (Cabrio top-load models) How to Fix Washer Error Unplug washer and verify lid closes fully without obstruction.…
-

How to Fix Kenmore Washer Error F09
Problem: Drainage timeout – long drain detected How to Fix Washer Error Turn off power supply. Remove lower front access panel. Check drain hose for kinks,…
-

How to Fix Whirlpool Washer Error drn
Problem: Drain system fault – water not draining within expected time How to Fix Washer Error Unplug washer and prepare for water drainage. Remove 3 torx…
-

How to Fix Kenmore Dishwasher Error F13
Problem: Overheating condition detected How to Fix Dishwasher Error Check water temperature entering dishwasher (should not exceed 140°F). Test high-limit thermostat operation. Inspect heating element for…
