How to Fix Maytag Washer Error F1E2

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: F1E2 Difficulty: Moderate

Problem: Motor control error or motor drive module fault

How to Fix F1E2 Error

UNPLUG THE WASHER. This is a critical error indicating a fault in the Motor Control Unit (MCU).
The MCU is located at the bottom of the washer, attached near the drive motor. You will need to tilt the washer back or lay it on its front (on protective blankets) to access the bottom panel.
Check all wire harness connections to the MCU and the motor for a secure fit. Look for any signs of damage or burnt components.
If all wiring is intact, the MCU has failed and must be replaced. Disconnect the harnesses, remove the mounting screws, and swap the board.

OEM Part #: W10374126 (Motor Control Unit – MCU)

Estimated Market Price: N/A

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your Maytag model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Maytag error codes: Maytag Error Codes