Safety Warning: Appliance repair involves electricity, gas, sharp edges, and moving parts. Always disconnect power (and shut off gas or water where applicable) before working on any appliance, and stop immediately if you are unsure or not qualified to perform a repair.
Error Code: Sanitize LED Difficulty: Mod
Problem: Control panel could not detect sanitation temperature achievement
⚖️ Repair Decision
⚠️ CHECK WARRANTY / AGE
$100 – $250 Range
Estimated Part Cost: $140
How to Fix Sanitize LED Error
- Check water temperature during sanitize cycle (must reach 150°F).
- Test temperature sensor accuracy and calibration.
- Verify heating element operation during sanitize cycle.
- Check control board sanitize cycle programming.
- Inspect water circulation during high-temperature phases.
- Replace temperature sensor or control board if needed.
⚡ Don’t Risk a DIY Fail!
Get the Official Service Manual for your specific model before you unscrew anything.
Instant PDF Download • Factory Authorized
Recommended Replacement Part
OEM Part #: WPW10134373
Market Price: $140
⚡ Don’t Risk a DIY Fail!
Get the Official Service Manual for your specific model before you unscrew anything.
Instant PDF Download • Factory Authorized
⚡ Don’t Risk a DIY Fail!
Get the Official Service Manual for your specific model before you unscrew anything.
Instant PDF Download • Factory Authorized
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse More Kenmore Codes
Need help with a different error? Check our complete list:
Leave a Reply