How to Fix Frigidaire Washer Error EF2

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: EF2 Difficulty: Easy

Problem: Too much soap.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix EF2 Error (Step-by-Step)

Cancel the current wash cycle and confirm the error stays cleared during a full test cycle.
Let the washer sit for a while to allow the suds to dissipate.
Select a ‘Rinse & Spin’ cycle and run it without any detergent to help clear the soap from the tub.
You may need to run a second rinse cycle if a large amount of suds remains.
Always use detergent specifically made for High-Efficiency (HE) washers and confirm the error stays cleared during a full test cycle.
Carefully measure your detergent according to the load size and water hardness. Using too much is the primary cause of this error.
Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.