How to Fix Frigidaire Washer Error E5D

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E5D Difficulty: Hard

Problem: Communication problem/failure.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix E5D Error (Step-by-Step)

Unplug the washer from the electrical outlet and confirm the error stays cleared during a full test cycle.
Remove the top and rear panels to get full access to the internal wiring and control boards.
Locate the main control board (usually at the top) and the motor control board (at the bottom, near the motor).
Carefully inspect the wiring harness that runs between these two boards. Look for any loose connections, pinched wires, or signs of damage.
Disconnect and then firmly reconnect the harness at both the main board and the motor control board ends.
If the wiring appears intact, the motor control board is the most likely component to have failed. Proceed to replace it following the steps for error E5A.
Reassemble the panels and test the washer and confirm the error stays cleared during a full test cycle.
Turn the appliance off, wait about 2 minutes, then turn it back on.

OEM Part #: 134743500 (Motor Control Board)

Estimated Market Price: $154-$300

Verified Compatible Alternatives:

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.