How to Fix Frigidaire Washer Error E5A

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E5A Difficulty: Hard

Problem: High temperature on the heat sink.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix E5A Error (Step-by-Step)

Disconnect the washer from the power outlet and confirm the error stays cleared during a full test cycle.
Remove the rear access panel of the washer by taking out the screws holding it in place.
Locate the motor control board, which is a circuit board situated near the main drive motor at the bottom of the machine.
Take a clear photo of the wire connections before proceeding.
Disconnect all wire harnesses from the board. They are secured with locking tabs.
Remove the screws mounting the board to the washer’s frame and install the new board.
Reconnect the wires using your photo as a guide, then replace the rear panel.
Turn the appliance off, wait about 2 minutes, then turn it back on.

OEM Part #: 134743500 (Motor Control Board)

Estimated Market Price: $154-$172

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.