How to Fix Frigidaire Washer Error E48

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E48 Difficulty: Moderate

Problem: The control board thinks the door PTC circuit is closed.

⚖️ Repair Decision

✅ WORTH FIXING

Parts under $100

How to Fix E48 Error (Step-by-Step)

Unplug the washer from the wall for safety and confirm the error stays cleared during a full test cycle.
Open the door and locate the metal or plastic clamp ring on the outside of the rubber door seal. Use pliers to expand and remove this clamp.
Fold the rubber door seal back into the drum to access the door lock assembly.
Unscrew the two screws holding the door lock assembly to the front panel of the washer.
Disconnect the wiring harness from the back of the old lock assembly.
Connect the new lock assembly to the wiring harness and secure it to the front panel with the screws.
Re-secure the rubber door seal with the clamp, ensuring it is evenly seated.
Turn the appliance off, wait about 2 minutes, then turn it back on.

OEM Part #: 131763256 (Door Lock Assembly)

Estimated Market Price: $65-$73

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.