How to Fix Amana Dryer Error E2

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E2 Difficulty: Moderate

Problem: Indicates a shorted thermistor, causing the dryer to misread the temperature.

⚖️ Repair Decision

✅ WORTH FIXING

Parts under $100

How to Fix E2 Error (Step-by-Step)

Ensure the dryer is completely disconnected from the power by unplugging the power cord from the wall socket.
To access the internal components, you will need to remove the rear service panel by unscrewing the screws that hold it in place.
Identify the thermistor, which is a small sensor responsible for reading the air temperature. It is usually located on the blower housing and has two wires attached.
Gently unplug the wire connector from the thermistor and confirm the error stays cleared during a full test cycle.
Use a screwdriver or nut driver to remove the screw holding the thermistor in place, then remove the old thermistor.
Position the new thermistor in the same spot, fasten it with the screw, and securely plug the wire connector back in.
Reinstall the rear service panel, plug the dryer in, and start a cycle to verify that the repair was successful.
Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Dryer

Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.

Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts.
Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path.
For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output.
For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts.

Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.

Next Steps and Parts

Recommended Replacement Part

OEM Part #: WP8577274

Estimated Market Price: $15-$71

Check Price & Availability →

&tag=appliancefixg-20

Verified Compatible Alternatives:

WP35001191

When It’s Better to Replace Than Repair

Dryer repairs are often worth it for small parts, but repeated heating, motor, drum, or control failures can point toward replacement.
Confirm gas vs electric, venting, voltage, doorway clearance, and laundry-space dimensions before ordering.
For repair parts, verify exact fit with the full dryer model number before buying; these links are general replacement-appliance shopping options.