⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: SUD OR SD Difficulty: Easy
Problem: Excessive suds have been detected in the dishwasher. This is often caused by using the wrong type or too much detergent.
How to Fix SUD OR SD Error (Step-by-Step)
- Press the ‘Cancel/Drain’ button to stop the cycle and drain the sudsy water.
- Open the dishwasher door and carefully remove all dishes and confirm the error stays cleared during a full test cycle.
- Use a towel to absorb the excess suds from the bottom of the dishwasher tub.
- Pour about 1 cup of white vinegar into the bottom of the dishwasher to help break down the remaining suds.
- Close the door and run a full ‘Rinse Only’ or a short wash cycle with no dishes and no additional detergent.
- To prevent this from happening again, always use a detergent specifically designed for automatic dishwashers and use the correct amount as recommended by the manufacturer.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes


Leave a Reply