Error Code: SANITIZE LIGHT FLASHING Difficulty: Moderate
Problem: The water is not hot enough to sanitize the dishes.
How to Fix SANITIZE LIGHT FLASHING Error (Step-by-Step)
- Before starting a cycle, run the hot water at the kitchen sink for a minute until it is hot. This ensures the dishwasher fills with hot water from the start.
- Check your home’s water heater settings. The temperature should be set to at least 120°F (49°C) for the dishwasher to sanitize properly.
- Turn the appliance off to the dishwasher at the circuit breaker.
- To access the heating element, you may need to pull the dishwasher out from under the counter. The element is a circular tube at the bottom of the dishwasher tub.
- Visually inspect the heating element for any signs of damage or breaks. You can test it for continuity with a multimeter.
- Locate the high-limit thermostat, usually mounted on the bottom of the tub. Test it for continuity as well.
- If either the heating element or thermostat is faulty, it will need to be replaced.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- W10814355
- W11305293
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Amana error codes: Amana Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply