Error Code: ALL CYCLE AND OPTION LIGHTS FLASHING Difficulty: Easy
Problem: The cycle has been suspended, usually because the door was opened during operation.
How to Fix ALL CYCLE AND OPTION LIGHTS FLASHING Error (Step-by-Step)
- Close the Door: This error typically means the cycle was interrupted. Ensure the dishwasher door is firmly closed and latched.
- Press the Start/Resume Button: Press the ‘Start/Resume’ button one time to continue the cycle from where it left off.
- Select a New Cycle (If Needed): If pressing ‘Start/Resume’ does not work, press the ‘Cancel’ button to drain the unit. You can then select a new wash cycle.
- Check for Obstructions: Make sure no dishes are blocking the door from closing properly or interfering with the detergent dispenser.
- Power Cycle the Dishwasher: If the lights continue to flash, turn off the power to the dishwasher at the circuit breaker for one minute, then turn it back on to reset the control panel.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
- Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.
What to Check Next on This Amana Dishwasher
Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated.
- Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication.
- Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board.
- If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Parts to Check
No exact official OEM part number is listed here because the correct Amana dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims.
-
Whirlpool dishwasher drain pumpCommon replacement category: Drain pumpFit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.Why this category can matter: standing-water, drain, and no-complete-cycle symptoms after the filter and hose are checked.
-
Whirlpool dishwasher water inlet valveCommon replacement category: Water inlet valveFit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.Why this category can matter: fill, low-water, or no-water symptoms after supply and float checks.
-
Whirlpool dishwasher control boardCommon replacement category: Electronic control boardFit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.Why this category can matter: repeating error-code or control faults after wiring and latch checks.
Before ordering: match the part to the complete Amana dishwasher model number on the appliance tag.
When It’s Better to Replace Than Repair
Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.
- [OK]Drain pump or circulation pump failure
- [OK]Leaking tub, door, or float-switch issues
- [OK]Heater or control failures on an older unit
- [OK]Repeated poor washing or drying performance
Recommended Dishwasher Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply