Amana Dishwasher Error ALL-CYCLE-AND-OPTION-LIGHTS-FLASHING-4

How to Fix ALL CYCLE AND OPTION LIGHTS FLASHING Error (Step-by-Step) Press the ‘Cancel/Drain’ button to reset the dishwasher and see if the lights turn off. Open and firmly close the dishwasher door to ensure the latch is fully engaged. Turn off the circuit breaker for the dishwasher for 5 minutes to reset the electronic control board. If the lights continue to flash, inspect the door latch and switch assembly for any visible damage or loose wires. Test the door switch with a multimeter for continuity. If there is no continuity when the switch is activated, it needs to be replaced. If the door switch is working correctly, the issue may be with the main control board, which may require professional replacement. Turn the appliance off, wait about 2 minutes, then turn it back on. Amana Dishwasher Checks Before Replacing Parts Cut power at the breaker for at least one minute, then restore power and run a short cycle to see whether the same code or light pattern returns. Open the door and inspect the latch, strike, racks, spray arms, float, filter, and lower sump for anything that can interrupt the cycle or block water movement. Check the drain hose loop, sink knockout, disposer connection, and air gap if the symptom involves standing water, repeated draining, or a cycle that will not complete. Use the complete model number from the door or tub tag before ordering any pump, valve, latch, heater, sensor, or control-board category part. If the fault returns immediately after these checks, document the exact lights, beeps, and cycle stage; repeated electronic faults usually need meter testing before parts are replaced. Recommended Parts to Check Use these as symptom-based starting points, then confirm the exact fit with the full Amana dishwasher model number from the door or tub tag before ordering. Start here Amana dishwasher drain pump Most likely when: water stays in the tub, draining sounds weak, or the cycle stops before completing. Check first: filter, drain hose, disposer knockout, air gap, and the drain path. Find compatible Amana dishwasher drain pumps Also check Amana dishwasher water inlet valve Most likely when: the tub does not fill, fills slowly, or stops early after the supply checks out. Check first: shutoff valve, float, inlet screen, water pressure, and harness connection. Find compatible Amana dishwasher inlet valves If controls act up Amana dishwasher control board Most likely when: lights stay stuck, buttons do not respond normally, or the fault returns after wiring and reset checks. Check first: breaker reset, door switch signal, keypad response, visible board damage, and loose connectors. Find compatible Amana dishwasher control boards If the door interrupts cycles Amana dishwasher door latch or switch Most likely when: the cycle starts and stops, lights blink after closing, or symptoms change when the door is moved. Check first: latch strike alignment, door seal pressure, connector fit, and switch continuity. Find compatible Amana dishwasher door latch switches