Maytag Dryer Error F4E2

The answer you came for

How to fix Maytag dryer error F4E2

Start with the safest checks and work from simple to technical.

1. 1

   IMMEDIATE ACTION

   IMMEDIATE ACTION: Disconnect power at circuit breaker—stuck relay creates fire hazard.

2. 2

   Remove rear panel to access heater assembly

   Remove rear panel to access heater assembly.

3. 3

   Inspect heating element for signs of severe overheating

   Inspect heating element for signs of severe overheating (melted terminals, discolored housing).

4. 4

   Check thermal fuse WP3392519 on blower housing—replace if

   Check thermal fuse WP3392519 on blower housing—replace if blown (likely tripped from overheating).

5. 5

   Remove control board WPW10111608 and locate heater relay

   Remove control board WPW10111608 and locate heater relay.

6. 6

   Visually inspect relay contacts for welding/sticking—contacts fused together

   Visually inspect relay contacts for welding/sticking—contacts fused together indicate failure.

7. 7

   Test relay contacts for continuity with power disconnected—should

   Test relay contacts for continuity with power disconnected—should show open circuit. Continuity indicates welded contacts.

8. 8

   Control board cannot be repaired—replace entire WPW10111608 assembly

   Control board cannot be repaired—replace entire WPW10111608 assembly.

9. 9

   Before reinstalling, verify blower wheel rotates freely and

   Before reinstalling, verify blower wheel rotates freely and entire vent system is clear to prevent recurrence of overheating.

10. 10

    After replacement, run short test cycle monitoring exhaust

    After replacement, run short test cycle monitoring exhaust temperature with infrared thermometer—should cycle on/of every 45-60 seconds, not heat continuously.