⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Dryer Difficulty: Hard
Problem: Control board EEPROM failure or corrupted software
How to Fix Dryer Error
- Disconnect power for 5 minutes to attempt soft reset—this clears temporary memory errors.
- Restore power and check if error persists.
- If error remains, enter diagnostic mode per model-specific procedure (typically holding two buttons during power-on).
- Run all diagnostic tests, noting any additional fault codes stored in memory.
- Check all wiring harnesses connected to main control board WPW10111608 for loose connections, corrosion, or damage—reseat each connector firmly.
- Inspect board for visible damage: burnt components, leaking capacitors, or water damage.
- If board appears physically intact but error persists after harness inspection, EEPROM corruption is likely.
- Replace main control board WPW10111608 with exact model match.
- After installation, enter setup mode to configure cycle options and language settings per manufacturer instructions.
- Run full diagnostic cycle to verify all functions operate correctly.
As an Amazon Associate, we earn from qualifying purchases through links on this page.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Maytag model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Maytag error codes: Maytag Error Codes
Leave a Reply