Amana Dishwasher Error ALL-CYCLE-AND-OPTION-LIGHTS-FLASHING-7

How to Fix ALL CYCLE AND OPTION LIGHTS FLASHING Error (Step-by-Step) Close the Door: This error typically means the cycle was interrupted. Ensure the dishwasher door is firmly closed and latched.Press the Start/Resume Button: Press the 'Start/Resume' button one time to continue the cycle from where it left off.Select a New Cycle (If Needed): If pressing 'Start/Resume' does not work, press the 'Cancel' button to drain the unit. You can then select a new wash cycle.Check for Obstructions: Make sure no dishes are blocking the door from closing properly or interfering with the detergent dispenser.Power Cycle the Dishwasher: If the lights continue to flash, turn off the power to the dishwasher at the circuit breaker for one minute, then turn it back on to reset the control panel.Turn the appliance off, wait about 2 minutes, then turn it back on.Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.

What to Check Next on This Amana Dishwasher Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated. Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication. Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board. If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. Recommended Parts to Check No exact official OEM part number is listed here because the correct Amana dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Whirlpool dishwasher drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying. Why this category can matter: standing-water, drain, and no-complete-cycle symptoms after the filter and hose are checked. Search Amazon for Whirlpool dishwasher drain pump Whirlpool dishwasher water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying. Why this category can matter: fill, low-water, or no-water symptoms after supply and float checks. Search Amazon for Whirlpool dishwasher water inlet valve Whirlpool dishwasher control board Common replacement category: Electronic control board Fit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying. Why this category can matter: repeating error-code or control faults after wiring and latch checks. Search Amazon for Whirlpool dishwasher control board Before ordering: match the part to the complete Amana dishwasher model number on the appliance tag.