Amana Washer Error LID-LIGHT-FLASHING-2

How to Fix LID LIGHT FLASHING Error (Step-by-Step) Ensure the washer lid is completely closed and there are no clothes or other items obstructing it from shutting properly. Press the ‘Start/Pause’ button once to see if the machine will attempt to lock the lid again. Unplug the washer from the power outlet for 5 minutes to reset the control board, then plug it back in. Try to start a cycle again. If the light continues to flash, the lid lock mechanism is the most likely cause of the failure. Inspect the plastic striker on the lid itself to make sure it is not broken or misaligned, as it must fit into the lock assembly correctly. If the striker is intact, the lid lock and switch assembly, located under the top panel of the washer, has likely failed and will require replacement. Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Washer Focused repair path: washer fill, drain, spin, lock, pressure, motor, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Unplug the washer for one minute, then restart only to confirm whether the same code returns after a clean power cycle. Check load balance, detergent level, supply valves, inlet screens, drain hose height, and the drain path before replacing electronic parts. Inspect the lid or door lock, strike, harness, and connector if the symptom involves start, lock, or spin behavior. Match the timing of the fault to the likely part path: inlet valve, pressure sensor, drain pump, motor, lock assembly, wiring, or control. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. Verified Compatible Alternatives: W11307244 Recommended Parts to Check No exact official OEM part number is listed here because the correct Amana washer part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Whirlpool washer drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Amana washer model number. Confirm compatibility before buying. Why this category can matter: drain, no-spin, or water-removal symptoms after hose and filter checks. Search Amazon for Whirlpool washer drain pump Whirlpool washer water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Amana washer model number. Confirm compatibility before buying. Why this category can matter: fill, slow-fill, and valve-related symptoms after supply checks. Search Amazon for Whirlpool washer water inlet valve Whirlpool washer control board Common replacement category: Main control board Fit note: Exact OEM part number varies by complete Amana washer model number. Confirm compatibility before buying. Why this category can matter: repeating control or communication faults after connector checks. Search Amazon for Whirlpool washer control board Before ordering: match the part to the complete Amana washer model number on the appliance tag. Still Not Working? If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure. Browse all Amana error codes: Amana Error Codes