How to Fix Bosch Washer Error F19

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: F19 Difficulty: Hard

Problem: Water heating time exceeded.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix F19 Error (Step-by-Step)

Unplug the washing machine from the electrical outlet and confirm the error stays cleared during a full test cycle.
Remove the back panel of the washer to access the heating element, which is located at the bottom of the tub.
Disconnect the wires from the heating element terminals and confirm the error stays cleared during a full test cycle.
Loosen the nut that secures the heating element in place, but do not remove it completely.
Gently pry the old heating element out of the tub. This may require some force if it is sealed tightly.
Insert the new heating element into the tub, ensuring the rubber seal is properly seated. Tighten the retaining nut and reconnect the wires.
Reattach the back panel, plug in the washer, and run a hot water cycle to test the new element.
Turn the appliance off, wait about 2 minutes, then turn it back on.

OEM Part #: NTC Sensor

Estimated Market Price: $30-$300

Verified Compatible Alternatives:

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Bosch model. Includes an easy-to-read list of every error code and quick diagnostic tips.