⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: Washer Difficulty: Easy
Problem: No water detected entering washer during fill cycle
How to Fix Washer Error
- Verify both hot and cold water supply valves are fully open.
- Disconnect fill hoses from washer inlet valves and place in bucket.
- Turn on water supply briefly to verify adequate flow (should fill bucket rapidly).
- Clean inlet valve screens by removing hoses and brushing debris from brass fittings.
- Check for kinks in fill hoses or excessive length (>6 feet restricts flow).
- Access inlet valve assembly behind rear panel – test solenoid coils with multimeter (should read 500-1500 ohms).
- If solenoids test open/infinite resistance, replace water inlet valve assembly W
- Verify pressure switch hose is connected and not leaking air (causes False ‘full’ detection).
- Test operation with both hot and cold cycles to confirm proper fill.
- If water flows but error persists, replace pressure switch W
As an Amazon Associate, we earn from qualifying purchases through links on this page.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Whirlpool model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Whirlpool error codes: Whirlpool Error Codes
Leave a Reply