How to Fix Whirlpool Washer Error F1E1

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: Washer Difficulty: Hard

Problem: Main control board EEPROM failure – corrupted memory preventing normal operation

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix Washer Error

Unplug washer for 10 minutes to fully discharge board capacitors.
Remove top panel and locate main control board (CCU) in upper right cabinet area.
Inspect board for visible damage: burnt components, bulging capacitors, or moisture corrosion.
Check all wire harness connections for proper seating and corrosion – reseat firmly.
Verify 120V AC power supply to board is stable (no voltage sags during operation).
If board appears physically intact but error persists after power cycle, EEPROM corruption has occurred.
Main control board must be replaced – EEPROM cannot be reprogrammed in field service.
Install new CCU W10461397 and secure all mounting screws to prevent vibration damage.
After installation, run full diagnostic cycle to verify all functions operate correctly.
Note: Power surges often cause this failure – recommend installing whole-house surge protector to prevent recurrence.

OEM Part #: W10461397

Estimated Market Price: $220

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your Whirlpool model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Whirlpool error codes: Whirlpool Error Codes