⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: OE1 Difficulty: Moderate
Problem: Water overflow detected during the fill cycle. The cold water inlet valve may be mechanically stuck open, forcing water into the machine continuously.
How to Fix OE1 Error
- UNPLUG washer immediately. Drain any standing water from tub using emergency drain hose.
- Locate pressure switch at top rear of tub assembly. Disconnect vinyl air hose.
- Test switch operation with multimeter in continuity mode: with tub EMPTY, switch must read OPEN circuit.
- If switch reads CLOSED when tub is empty, it is mechanically stuck.
- Attempt to free switch by tapping gently with plastic tool while monitoring multimeter. If no change, replace switch.
- Install new pressure switch using OEM part DC34-00050A: disconnect wiring harness, remove mounting screws, position new switch.
- Reconnect vinyl hose securely to switch and air dome port. Ensure no kinks in hose path.
- Verify air dome port on tub is clear of lint/debris using flashlight and small brush.
- Restore power. Run fill cycle to confirm water stops at appropriate level without overflow.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Samsung model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Samsung error codes: Samsung Error Codes
Leave a Reply