How to Fix LG Microwave Error E-02

Lg Microwave Error E-02 overlay image

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E-02 Difficulty: Hard

Problem: The temperature in convection mode is not rising as it should.

⚖️ Repair Decision
⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix E-02 Error (Step-by-Step)

  1. Disconnect the microwave from the power source completely and confirm the error stays cleared during a full test cycle.
  2. Remove the outer casing of the microwave to get to the internal parts.
  3. Find the convection heater element, which is usually a circular element located at the back or top of the oven cavity, often behind a metal panel.
  4. Visually inspect the heater element for any visible breaks, burns, or damage.
  5. Use a multimeter to test the heater for continuity. If the multimeter shows no continuity, the heater element is broken and must be replaced.
  6. If the heater tests good, the problem may be the main control board not sending power to the heater.
  7. Replacing the main control board is a complex task; if you’ve determined it’s the cause, carefully label and disconnect all wires from the old board before installing the new one.
  8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Next Steps and Parts

Recommended Parts to Check

Compatibility note: Exact LG microwave part numbers vary by complete model number, production revision, and internal layout. Treat these as diagnostic part-category searches, then confirm fit with the full model number before ordering.
  • Start here
    LG microwave humidity sensor
    Common replacement category: Humidity or steam sensor
    Symptom match: Most likely when: error E-02 appears during sensor cooking, reheating, or shortly after steam builds.
    Check first: Check first: food splatter, blocked sensor airflow, and loose sensor connectors.

    Find compatible LG microwave humidity sensor

  • Also check
    LG microwave temperature sensor
    Common replacement category: Temperature sensor
    Symptom match: Most likely when: error E-02 follows heating or cooling changes.
    Check first: Check first: sensor resistance and harness continuity against the model service data.

    Find compatible LG microwave temperature sensor

  • Harness path
    LG microwave wire harness
    Common replacement category: Sensor harness
    Symptom match: Most likely when: error E-02 is intermittent or changes when the cabinet is moved.
    Check first: Check first: pinched wires, loose plugs, and corrosion before ordering parts.

    Find compatible LG microwave wire harness

  • Control path
    LG microwave control board
    Common replacement category: Electronic control board
    Symptom match: Most likely when: sensor and harness tests pass but error E-02 returns.
    Check first: Check first: board connectors and visible damage.

    Find compatible LG microwave control board

Model-number note: Use the LG microwave model tag before buying; these links are not universal fit claims.

LG Microwave Error E-02 Checks Before Replacing Parts

  1. Disconnect power before opening the cabinet, and do not touch high-voltage parts unless you are trained to discharge and test them safely.
  2. Confirm the full LG model number from the tag before matching any replacement category to the appliance.
  3. Check the simple symptom path first: door closure, keypad response, airflow, and any obvious loose or damaged connectors.
  4. Test switches, sensors, or harnesses with a meter where the service data supports it instead of ordering parts by code alone.
  5. If the related parts test correctly, inspect the control area and harness before considering a model-matched control board.

When It’s Better to Replace Than Repair

Microwave repairs require extra caution because high-voltage parts can retain a dangerous charge after unplugging.
Door switches, turntable motors, fuses, and controls may be replaceable, but many microwave failures are safer and cheaper to solve with replacement.
For repair parts or built-in trim kits, verify exact fit with the full microwave model number before buying; these links are general replacement-appliance shopping options.

  • [OK]Door switch or latch problems return after adjustment
  • [OK]Turntable motor, fuse, or control repairs approach replacement cost
  • [OK]High-voltage diode, capacitor, or magnetron is suspected
  • [OK]Over-the-range fit, venting, or keypad issues keep recurring

Recommended Microwave Replacement Options

Countertop Microwaves

Simple Plug-In Replacements

  • Fastest replacement path
  • Measure counter depth and door swing
  • Match wattage and capacity needs

Shop Countertop Microwaves

Over-the-Range

Microwave and Vent Hood Units

  • Confirm width, mounting bracket, and cabinet height
  • Match recirculating or exterior venting
  • Plan for two-person installation

Compare Over-the-Range Units

Built-In Trim Kits

Cabinet-Fit Microwave Options

  • Confirm trim-kit compatibility by model
  • Measure cabinet cutout before ordering
  • Do not assume old trim fits a new unit

View Built-In Options

Safety note: Do not service microwave high-voltage components unless you are trained and equipped to discharge and test them safely.

As an Amazon Associate, we earn from qualifying purchases.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

💬 Chat with a Certified Technician Now

Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)

⚡ Don’t Risk a DIY Fail!

Get the ‘Secret Service Mode’ Cheat Sheet for your LG model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download


Browse More Codes

📖 View All Error Codes

Expert: Mike Sullivan

EPA Section 608 Certified Technician with 18+ years experience.

Read Editorial Standards →